Bushnell 11-0832 Review, LED/SOUND Indications, Software Installation, Connection to the Computer

REVIEW

1)Photo number / Total Photos: Displays number of review photo / Total photos currently stored

2)Image Resolution: Indicates resolution of review photo

LED/SOUND INDICATIONS

LED (Red)

1)Power On indication: steady light

2)Operation indication: blinks to confirm image capture after “Snap”. LED goes out while photo is being stored in memory, comes on again when storage operation is complete.

3)Self Timer indication: blinks once per second during timer countdown.

Audible alerts (beeps)

1)Power on: 2 short beeps; Power off: 2 short beeps;

2)Operation confirmation: 1 short beep.

3)Saving photo completed: 1 short beep.

4)Memory full (download, then delete photos to reuse memory): 3 short beeps.

5)Low battery warning: 3 long beeps.

SYSTEM REQUIREMENTS (FOR INCLUDED PHOTOSUITE SOFTWARE):

Minimum:		Recommended:
•	Pentium® III 500 MHz	• 128 MB RAM
•	Windows® 98SE / Me / 2000 / XP	• 1024 x 768 screen display or higher
•	64 MB RAM	• 24-bit True color or higher
•	SVGA video card (2MB Video RAM)	• Internet access
•	800x600 screen display	• Photo quality color printer
•	16-bit High color
•	200 MB Hard Disk space available
•	CD-ROM drive
8 •	USB port

SOFTWARE INSTALLATION:

A. DRIVER SOFTWARE INSTALLATION (ONLY NECESSARY FOR WINDOWS 98/98SE)

If the CD-ROM does not automatically launch the install screen, double click “ SETUP.EXE” in the CD-ROM file directory to start the installation.

Press [Next] to continue

As noted, be sure the camera is not plugged into your computer’s USB port before proceeding with the installation.

Then press [Next] to continue.

When the driver installation has completed, press [Finish] to end

CONNECTION TO THE COMPUTER

1.Be sure the computer has finished installing the hardware driver.

2.Plug the small connector at one end of the supplied USB cable into the port above the SD card slot on the back of the camera (see fig.3). Plug the flat end of the USB cable directly into an available USB port on your computer (avoid the use of USB hubs).

3.The computer will identify the camera automatically.

9