Other Setup Notes
1. SD CARD SLOT
The unit has a standard SD Card slot. You must push the SD Card in with the SD Card label facing the Bushnell logo into the SD card slot. Pushing it again will release the SD card, and then you can remove the SD card from the SD card slot. Insertion or removal of SD card is only recommended when the unit is in the “OFF” position.
2. PIR SENSOR
The sensor that triggers the trail camera is Passive InfraRed, or PIR. Infrared energy is essentially heat energy. The PIR detector operates by sensing a change in the infrared level in its detection zone. This zone is a cone in the center 10 degrees of the camera’s field of view. The camera establishes an average
In the Setup mode, you can use PIR sensor to determine the detection zone .When the PIR is sensed, the PIR Sense Indicator will light. The camera’s field of view is a 45 degree cone, centered on the PIR detection zone.
15