Cable Electronics HSW44C Operation and IR Control

Source Side

Method A: Push Button

Push the switch button on the front panel, the source will be sequentially changed.

Method B: IR Remote Control

a. Please press to enter IR control mode

Note

If HSW44C receives the IR commands, the LED will flash. If not, try again.

b. Decide which output port to be controlled by pressing F1 to F4

Note

If the setting is correct, the corresponding LED will flash. If not, please press output port select button or repeat

step (a) and (b).

F1 HDMI output #1

F2 HDMI output #2

F3 HDMI output #3

F4 HDMI output #4

c. Use or keys to select input source.

Note

If the setting is correct, the corresponding LED will flash. If there is no

response, please wait until the LED stops flashing, and try again.

Left button to switch channels in ascending order (1, 2, 3, 4, 1, ...)

Right button to switch channels in descending order (1, 4, 3, 2, 1, …)

Operation and IR Control

Contents

Main HSW44C 4x4 HDMI Matrix Switch Instruction Manual with CAT5 Output Safety and Notice Introduction Features Specifications & Package Contents Page HSW44C Panel Descriptions HSMR * DIP Switch for EDID/Audio Note for firmware update (for technical support only) Note IR Cables IR Sockets IR Extender Definition of IR Earphone Jack Supported IR Data Format HSW44C as master HSMR as receiver Hardware Installation Source Side Method A: Push Button Operation and IR Control Display Side Method A: Push button Method B1: IR remote control for switching input channels Method B2: IR remote control for controlling the HDMI sources RS 232 Serial Port Control - Page RS - 232 Commands Firmware Updat e Page Performance Guide for HDMI over LAN Cable Transmission Notice Warranty