INSTALLATION
Reinsert the screw removed in disassembly and replace the PC cover. Reattach the power and peripheral cables and turn on the power for the PC and the peripherals.
2.7INSTALLING THE E3100 SERIES ADAPTERS
This section contains instructions for preparing and installing your Cabletron Systems E3100 Series network adapter into your computer. The only hardware preparation for installing the E3100 Series adapter is the installation of an optional Boot PROM.
2.7.1 Preparing the E3100 Series for Installation
The parameters for the E3100 Series adapters are set when the Adapter Description File (ADF) is configured. The ADF file distinguishes the adapter from other boards in the computer. The ADF will be configured after the adapter is installed.
CAUTION: The adapter is sensitive to static discharges. Hold it by the corners. Avoid contact with the PC bus edge connector or any of the components. Failure to observe all static precautions may result in damage to the adapter.
2.7.2 E3100 Series Boot PROM
The E3100 Series adapters each have a socket for an optional Boot PROM, which is purchased separately. By installing a Boot PROM, you can use the adapter to boot up your PC, without a hard drive, onto a network running for example, the Novell® NetWare network operating system. The Boot PROM is configured with the necessary parameters when configuring the Adapter Description File, as described in Section 2.8. Refer to Figure
CAUTION: Observe all precautions when handling the Boot PROM. Static discharges may damage the Boot PROM.
Page
