Manuals / Cabletron Systems / Computer Equipment / Network Card

Cabletron Systems manual Chapter Installation, UNPACKING THE HSIM-W85

Models: W85

1 60

Download 60 pages 41.11 Kb

Page 23

CHAPTER 2

INSTALLATION

To install the HSIM-W85 the following items are required:

•Antistatic wrist strap (shipped with the HSIM-W85)

•Phillips screwdriver

NOTE

Before attempting to use the HSIM-W85 you should be familiar with the IEEE 802.3 Speciﬁcations,and T1 Networking.

2.1UNPACKING THE HSIM-W85

!

CAUTION

The HSIM-W85 and the host platform are sensitive to static discharges. Use an antistatic strap and observe all static precautions during this procedure. Failure to do so could result in damage to the HSIM-W85 or host platform.

Unpack the HSIM-W85 as follows:

1.Remove the HSIM-W85 from the shipping box.

2.Leave the module in its antistatic bag until you are ready to install it.

3.Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap package for proper use).

4.After removing the module from its antistatic bag, visually inspect the device. If you notice any signs of damage, contact Cabletron Systems immediately. Refer to Section 1.8 for instructions. Save the antistatic bag in the event the module must be reshipped or relocated.

HSIM-W85 User’s Guide

2-1

Image 23

Cabletron Systems manual Chapter Installation, UNPACKING THE HSIM-W85

Contents

HSIM-W85 HSIM-W85 User’s Guide9032842-01 Page HSIM-W85 User’s Guide Only qualiﬁed personnel should perform installation proceduresHSIM-W85 User’s Guide FCC NOTICEINDUSTRY CANADA NOTICE BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT VCCI NOTICECABLETRON SYSTEMS, INC PROGRAM LICENSE AGREEMENT HSIM-W85 User’s Guide4. EXPORT REQUIREMENTS. You understand that Cabletron and its Affiliates are subject to regulation by agencies of the U.S. Government, including the U.S. Department of Commerce, which prohibit export or diversion of certain technical products to certain countries, unless a license to export the product is obtained from the U.S. Government or an exception from obtaining such license may be relied upon by the exporting party HSIM-W85 User’s GuideCAREFULLY READ THIS LICENSE AGREEMENT CABLETRON SYSTEMS SALES AND SERVICE, INC PROGRAM LICENSE AGREEMENTHSIM-W85 User’s Guide BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCTCAREFULLY READ THIS LICENSE AGREEMENT CABLETRON SYSTEMS LIMITED PROGRAM LICENSE AGREEMENTHSIM-W85 User’s Guide BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCTHSIM-W85 User’s Guide HSIM-W85 User’s Guide viiiINTRODUCTION CONTENTSINSTALLATION CHAPTERAPPENDIX B TYPICAL CONFIGURATION ContentsTROUBLESHOOTING SPECIFICATIONS1.1 FIRMWARE REVISION Important Notice CHAPTER INTRODUCTIONChapter 1 Introduction 1.2 USING THIS MANUAL1.3 OVERVIEW 1.4 DATA FLOW IN THE HSIM-W85 1.5 FEATURES1.5.2 HDLC 1.5.1 Connectivity1.5.4 Priority Queuing 1.5.3 Inverse Multiplexing IMUX1.5.6 SNMP and MIB Support 1.5.5 DS1 Alarm1.5.7 LANVIEW Diagnostic LEDs bold type 1.6 DOCUMENT CONVENTIONSThe following conventions are used throughout this document Chapter 1 Introduction1.7 RELATED DOCUMENTATION 1.8 GETTING HELP 2.1 UNPACKING THE HSIM-W85 CHAPTER INSTALLATIONOnly qualiﬁed personnel should install or service this unit 2.2 INSTALLING THE HSIM-W852.2.1 Installing the HSIM-W85 in an Interface Module HSIM Coverplate Faceplate Mounting Screws Host Platform Installing the HSIM-W85HSIM-W85 User’s Guide Figure 2-1 Removing the HSIM Coverplate7. Align the connector on the HSIM-W85 with the pins on the module 2.2.2 Installing the HSIM-W85 in a Standalone Device Figure B-3 HSIM-W85 Cable Connection 2.3 CONNECTING THE HSIM-W85 TO THE NETWORKHSIM-W85 User’s Guide CHAPTER LANVIEW LEDs3.1 LANVIEW LEDS HSIM-W85 LEDs Chapter 3 LANVIEW LEDsHSIM-W85 User’s Guide 4.1 LOCAL MANAGEMENT CHAPTER MANAGEMENTFigure 4-1 Typical Hierarchy of Local Management Screens Configuration MenuChapter 4 Management HSIM-W85 User’s Guide4.2 NETWORK TOOLS Important Notice4.2.1 Commands There are two categories of commands in the command set command imux 4.2.2 Built-in CommandsExample Example wanpqSyntax ds1alarm ds1alarmExample dsx1Syntax Example Options dsx1 with no options lists a summary of the DS1 conﬁgurationSyntax ds1ext ds1extOptions 4.2.3 Special Commandsdone, quit, exit Description4.3 SAMPLE IMUX CONFIGURATION Figure 4-4 Enabling the IMUX Group Chapter 4 Management4-16 HSIM-W85 User’s Guide4-17 Sample IMUX ConﬁgurationHSIM-W85 User’s Guide HSIM-W85 User’s Guide Chapter 4 Management4-18 5.1.1 Hardware Troubleshooting CHAPTER TROUBLESHOOTING5.1 TROUBLESHOOTING THE HSIM-W85 Verify the framing, zero suppression Device not forwarding packets 5.1.2 Investigating Software Conﬁguration Problems5.1.3 Problems with the Firmware Image HSIM-W85 User’s Guide Chapter 5 TroubleshootingHSIM-W85 User’s Guide APPENDIX A SPECIFICATIONSPHYSICAL PROPERTIES HSIM-W85 User’s Guide A.2 ENVIRONMENTAL REQUIREMENTSA.3 REGULATORY COMPLIANCE Appendix A SpeciﬁcationsAPPENDIX B TYPICAL CONFIGURATION HSIM-W85 User’s Guide T1 Configuration IMUX ConfigurationconfigW85 Appendix B Typical ConﬁgurationUSOC APPENDIX C FCC PART 68 - USER’S INFORMATIONPort ID REN/SOC7. The attached affidavit must be completed by the installer For the work to be performed in the certiﬁed territory of accordance with