Manuals / Cabletron Systems / Computer Equipment / Network Card

Cabletron Systems INSTALLING THE HSIM-W85, Installing the HSIM-W85 in an Interface Module

Models: W85

1 60

Download 60 pages 41.11 Kb

Page 24

2.2INSTALLING THE HSIM-W85

Chapter 2: Installation

2.2INSTALLING THE HSIM-W85

Only qualiﬁed personnel should install or service this unit.

An HSIM-W85 can be installed in any Cabletron Systems device that supports HSIM technology (e.g., 2H252-25R, 2E42-27, 6E132-25).

NOTE

Refer to the release notes for the version of ﬁrmware running on the Cabletron Systems host platform to ensure that the HSIM-W85 is supported.

The following subsections provide instructions for installing an HSIM-W85 in a host platform. Refer to the speciﬁc interface module or standalone device manual for exact HSIM slot and connector locations.

2.2.1Installing the HSIM-W85 in an Interface Module

To install an HSIM-W85 in an interface module that supports HSIM technology, perform the following steps.

1.Note the ports of the interface module that have cables attached to them. Write down the ports and label the cables to make it easier to reattach the network properly after the installation. Then disconnect those cables from the ports.

2.Attach the antistatic wrist strap (refer to the instructions outlined on the antistatic wrist strap package).

3.If the interface module is installed in a chassis, unlock the top and bottom plastic locking tabs of the module faceplate.

4.Remove the module from the chassis, and place it down flat with the internal components facing up.

5.Remove and save the two faceplate mounting screws securing the HSIM coverplate and remove the coverplate. See Figure 2-1.

2-2	HSIM-W85 User’s Guide

Image 24

Cabletron Systems manual INSTALLING THE HSIM-W85, Installing the HSIM-W85 in an Interface Module

Contents

HSIM-W85 User’s Guide 9032842-01HSIM-W85 Page Only qualiﬁed personnel should perform installation procedures HSIM-W85 User’s GuideFCC NOTICE INDUSTRY CANADA NOTICEHSIM-W85 User’s Guide VCCI NOTICE CABLETRON SYSTEMS, INC PROGRAM LICENSE AGREEMENTHSIM-W85 User’s Guide BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCTHSIM-W85 User’s Guide 4. EXPORT REQUIREMENTS. You understand that Cabletron and its Affiliates are subject to regulation by agencies of the U.S. Government, including the U.S. Department of Commerce, which prohibit export or diversion of certain technical products to certain countries, unless a license to export the product is obtained from the U.S. Government or an exception from obtaining such license may be relied upon by the exporting partyCABLETRON SYSTEMS SALES AND SERVICE, INC PROGRAM LICENSE AGREEMENT HSIM-W85 User’s GuideBEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT CAREFULLY READ THIS LICENSE AGREEMENTCABLETRON SYSTEMS LIMITED PROGRAM LICENSE AGREEMENT HSIM-W85 User’s GuideBEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT CAREFULLY READ THIS LICENSE AGREEMENTHSIM-W85 User’s Guide viii HSIM-W85 User’s GuideCONTENTS INSTALLATIONCHAPTER INTRODUCTIONContents TROUBLESHOOTINGSPECIFICATIONS APPENDIX B TYPICAL CONFIGURATIONCHAPTER INTRODUCTION 1.1 FIRMWARE REVISION Important Notice1.2 USING THIS MANUAL Chapter 1 Introduction1.3 OVERVIEW 1.5 FEATURES 1.4 DATA FLOW IN THE HSIM-W851.5.1 Connectivity 1.5.2 HDLC1.5.3 Inverse Multiplexing IMUX 1.5.4 Priority Queuing1.5.5 DS1 Alarm 1.5.7 LANVIEW Diagnostic LEDs1.5.6 SNMP and MIB Support 1.6 DOCUMENT CONVENTIONS The following conventions are used throughout this documentChapter 1 Introduction bold type1.7 RELATED DOCUMENTATION 1.8 GETTING HELP CHAPTER INSTALLATION 2.1 UNPACKING THE HSIM-W852.2 INSTALLING THE HSIM-W85 2.2.1 Installing the HSIM-W85 in an Interface ModuleOnly qualiﬁed personnel should install or service this unit Installing the HSIM-W85 HSIM-W85 User’s GuideFigure 2-1 Removing the HSIM Coverplate HSIM Coverplate Faceplate Mounting Screws Host Platform7. Align the connector on the HSIM-W85 with the pins on the module 2.2.2 Installing the HSIM-W85 in a Standalone Device 2.3 CONNECTING THE HSIM-W85 TO THE NETWORK Figure B-3 HSIM-W85 Cable ConnectionCHAPTER LANVIEW LEDs 3.1 LANVIEW LEDSHSIM-W85 User’s Guide Chapter 3 LANVIEW LEDs HSIM-W85 User’s GuideHSIM-W85 LEDs CHAPTER MANAGEMENT 4.1 LOCAL MANAGEMENTConfiguration Menu Chapter 4 ManagementHSIM-W85 User’s Guide Figure 4-1 Typical Hierarchy of Local Management ScreensImportant Notice 4.2 NETWORK TOOLS4.2.1 Commands There are two categories of commands in the command set command 4.2.2 Built-in Commands imuxExample wanpq Exampleds1alarm Syntax ds1alarmdsx1 SyntaxExample Options dsx1 with no options lists a summary of the DS1 conﬁguration Exampleds1ext Syntax ds1ext4.2.3 Special Commands done, quit, exitDescription Options4.3 SAMPLE IMUX CONFIGURATION Chapter 4 Management 4-16HSIM-W85 User’s Guide Figure 4-4 Enabling the IMUX GroupSample IMUX Conﬁguration HSIM-W85 User’s Guide4-17 Chapter 4 Management 4-18HSIM-W85 User’s Guide CHAPTER TROUBLESHOOTING 5.1 TROUBLESHOOTING THE HSIM-W855.1.1 Hardware Troubleshooting Verify the framing, zero suppression 5.1.2 Investigating Software Conﬁguration Problems 5.1.3 Problems with the Firmware ImageDevice not forwarding packets Chapter 5 Troubleshooting HSIM-W85 User’s GuideAPPENDIX A SPECIFICATIONS PHYSICAL PROPERTIESHSIM-W85 User’s Guide A.2 ENVIRONMENTAL REQUIREMENTS A.3 REGULATORY COMPLIANCEAppendix A Speciﬁcations HSIM-W85 User’s GuideAPPENDIX B TYPICAL CONFIGURATION T1 Configuration IMUX Configuration configW85Appendix B Typical Conﬁguration HSIM-W85 User’s GuideAPPENDIX C FCC PART 68 - USER’S INFORMATION Port IDREN/SOC USOC7. The attached affidavit must be completed by the installer For the work to be performed in the certiﬁed territory of accordance with