Manuals / Cabletron Systems / Computer Equipment / Network Card

Cabletron Systems manual Align the connector on the HSIM-W85 with the pins on the module

Models: W85

1 60

Download 60 pages 41.11 Kb

Page 26

Image 26

Chapter 2: Installation

Connector

Cutaway view of connector

Standoff Screws

Connector

HSIM-W85

L
S	L
	L
	S	L
		L
		S	L
			L
			S	L
				L
				S	L
					S	L
						S	L
							L
							S HSIM-
							W85
							CPU

HSIM

Pins

Standoffs

Faceplate Mounting Screws

Interface Module or Device

mounting

Figure 2-2 Installing the HSIM-W85

7.Align the connector on the HSIM-W85 with the pins on the module.

Ensure that the HSIM-W85 connector aligns with the module

!connector pins to prevent bending the pins. This can damage

CAUTION	both the HSIM-W85 and the module.

8.Press down firmly on the connector area of the HSIM-W85 until the connector slides all the way onto the pins. Ensure that the standoffs on the interface module align with the standoff screw holes on the HSIM-W85.

9.Secure the HSIM-W85 to the module faceplate using the mounting

screws saved in step 5.

2-4	HSIM-W85 User’s Guide

Page 26

Image 26

Cabletron Systems manual Align the connector on the HSIM-W85 with the pins on the module

Contents

HSIM-W85 HSIM-W85 User’s Guide9032842-01 Page Only qualiﬁed personnel should perform installation procedures HSIM-W85 User’s GuideHSIM-W85 User’s Guide FCC NOTICEINDUSTRY CANADA NOTICE HSIM-W85 User’s Guide VCCI NOTICECABLETRON SYSTEMS, INC PROGRAM LICENSE AGREEMENT BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCTHSIM-W85 User’s Guide 4. EXPORT REQUIREMENTS. You understand that Cabletron and its Affiliates are subject to regulation by agencies of the U.S. Government, including the U.S. Department of Commerce, which prohibit export or diversion of certain technical products to certain countries, unless a license to export the product is obtained from the U.S. Government or an exception from obtaining such license may be relied upon by the exporting partyBEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT CABLETRON SYSTEMS SALES AND SERVICE, INC PROGRAM LICENSE AGREEMENTHSIM-W85 User’s Guide CAREFULLY READ THIS LICENSE AGREEMENTBEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT CABLETRON SYSTEMS LIMITED PROGRAM LICENSE AGREEMENTHSIM-W85 User’s Guide CAREFULLY READ THIS LICENSE AGREEMENTHSIM-W85 User’s Guide viii HSIM-W85 User’s GuideCHAPTER CONTENTSINSTALLATION INTRODUCTIONSPECIFICATIONS ContentsTROUBLESHOOTING APPENDIX B TYPICAL CONFIGURATIONCHAPTER INTRODUCTION 1.1 FIRMWARE REVISION Important Notice1.2 USING THIS MANUAL Chapter 1 Introduction1.3 OVERVIEW 1.5 FEATURES 1.4 DATA FLOW IN THE HSIM-W851.5.1 Connectivity 1.5.2 HDLC1.5.3 Inverse Multiplexing IMUX 1.5.4 Priority Queuing1.5.6 SNMP and MIB Support 1.5.5 DS1 Alarm1.5.7 LANVIEW Diagnostic LEDs Chapter 1 Introduction 1.6 DOCUMENT CONVENTIONSThe following conventions are used throughout this document bold type1.7 RELATED DOCUMENTATION 1.8 GETTING HELP CHAPTER INSTALLATION 2.1 UNPACKING THE HSIM-W85Only qualiﬁed personnel should install or service this unit 2.2 INSTALLING THE HSIM-W852.2.1 Installing the HSIM-W85 in an Interface Module Figure 2-1 Removing the HSIM Coverplate Installing the HSIM-W85HSIM-W85 User’s Guide HSIM Coverplate Faceplate Mounting Screws Host Platform7. Align the connector on the HSIM-W85 with the pins on the module 2.2.2 Installing the HSIM-W85 in a Standalone Device 2.3 CONNECTING THE HSIM-W85 TO THE NETWORK Figure B-3 HSIM-W85 Cable ConnectionHSIM-W85 User’s Guide CHAPTER LANVIEW LEDs3.1 LANVIEW LEDS HSIM-W85 LEDs Chapter 3 LANVIEW LEDsHSIM-W85 User’s Guide CHAPTER MANAGEMENT 4.1 LOCAL MANAGEMENTHSIM-W85 User’s Guide Configuration MenuChapter 4 Management Figure 4-1 Typical Hierarchy of Local Management ScreensImportant Notice 4.2 NETWORK TOOLS4.2.1 Commands There are two categories of commands in the command set command 4.2.2 Built-in Commands imuxExample wanpq Exampleds1alarm Syntax ds1alarmExample dsx1Syntax Options dsx1 with no options lists a summary of the DS1 conﬁguration Exampleds1ext Syntax ds1extDescription 4.2.3 Special Commandsdone, quit, exit Options4.3 SAMPLE IMUX CONFIGURATION HSIM-W85 User’s Guide Chapter 4 Management4-16 Figure 4-4 Enabling the IMUX Group4-17 Sample IMUX ConﬁgurationHSIM-W85 User’s Guide HSIM-W85 User’s Guide Chapter 4 Management4-18 5.1.1 Hardware Troubleshooting CHAPTER TROUBLESHOOTING5.1 TROUBLESHOOTING THE HSIM-W85 Verify the framing, zero suppression Device not forwarding packets 5.1.2 Investigating Software Conﬁguration Problems5.1.3 Problems with the Firmware Image Chapter 5 Troubleshooting HSIM-W85 User’s GuideHSIM-W85 User’s Guide APPENDIX A SPECIFICATIONSPHYSICAL PROPERTIES Appendix A Speciﬁcations A.2 ENVIRONMENTAL REQUIREMENTSA.3 REGULATORY COMPLIANCE HSIM-W85 User’s GuideAPPENDIX B TYPICAL CONFIGURATION Appendix B Typical Conﬁguration T1 Configuration IMUX ConfigurationconfigW85 HSIM-W85 User’s GuideREN/SOC APPENDIX C FCC PART 68 - USER’S INFORMATIONPort ID USOC7. The attached affidavit must be completed by the installer For the work to be performed in the certiﬁed territory of accordance with