Cannon 20718, 195049764.00, 20715 Care and Cleaning, Oven Fittings, Oven Interiors, Panel Glass

Models: 20715 20718 195049764.00

1 32
Download 32 pages 26.68 Kb
Page 28
Image 28
Oven Fittings

Care and Cleaning

Oven Fittings

The oven shelves can be cleaned either in a dishwasher or by using a

 

fine steel wool soap pad. The grill and meat pans can be cleaned in warm

 

soapy water using a fine steel wool soap pad to remove stubborn stains

 

or in a dishwasher.

 

They should be cleaned after each use.

Oven Interiors

To clean the oven interiors remove all the oven fittings and where

 

applicable the ‘Heat Clean’ liners.

 

All types of oven cleaners can be used, but do not allow abrasive

 

cleaners or oven spray to come into contact with the ‘Heat Clean’ liners.

 

Use a fine steel wool soap pad to remove stubborn stains.

Oven Door Cleaning Wipe the outer door glass panels with a cloth wrung out in warm soapy water, then after wiping with a cloth wrung out in clear water, dry with a soft clean cloth. Ensure that the glass doors are not subjected to any sharp mechanical blows.

Glass inner door panel (where fitted) - open the door fully and unscrew the two screws securing the glass panel, taking care not to allow the glass to fall. The glass panel may now be washed at the sink. Stubborn stains can be removed using a fine steel wool soap pad. Ensure the glass panel is not subjected to any sharp mechanical blows. Take particular care not to damage the inner surface which is coated with a heat reflective layer. After cleaning, rinse and dry with a soft cloth. For slight soiling the inner glass panel may be cleaned, while still warm, without removing it from the door.

WARNING: Oven must not be operated with the inner door glass removed.

Take care during cleaning not to damage or distort the door seals. Do not lift the door seal from the oven chassis, if necessary remove the seal by carefully unhooking the corner clips.

Take care that the rating label edges are not lifted during cleaning and furthermore, that the lettering is not blurred or removed.

Cooker Exterior The outside of the cooker should be cleaned regularly to keep it looking like new.

Wipe over with a soft cloth wrung out in warm water and dry with a soft clean cloth.

You can use mild non abrasive cleaners but always read the manufacturer’s instructions first. Always test their suitability on a small area of the cooker not noticeable in normal use.

Note: Do not use scouring pads or abrasive cleaners as they may scratch the surface.

Wear protective gloves when cleaning any part of your cooker.

Door and Control Regularly wipe with a clean, damp cloth and polish with a clean, dry cloth.

Panel (Glass)

WARNING: TO AVOID ELECTRIC SHOCK, BEFORE REPLACING THE OVEN LIGHT, SWITCH THE COOKER OFF AT THE COOKER CONTROL UNIT (and allow to cool if the oven has been used).

Replacement of the Oven Light

Unscrew the glass cover, using a suitable cloth to protect the fingers and remove carefully. Unscrew the existing light bulb, and remove. Screw the new bulb into position and replace the glass cover, with metal washer, until positioned securely.

28

Page 28
Image 28
Cannon 20718, 195049764.00 Care and Cleaning, Oven Fittings, Oven Interiors, Panel Glass, Replacement of the Oven Light