KitchenAid 2209477 Base grille, Using the dispenser without a water filter, Ordering replacement filters

16
Base grille
To remove:
1. Remove one screw at each end of the base grille.
2. Remove base grille.
3. Replace in reverse order.
5. With cartridge cap in the vertical position, push the
new filter cartridge into the base grille until it stops.
Rotate the cartridge cap clockwise to a horizontal
position.
6. RUN WATER THR OUGH THE DISPENSER UNTIL
THE WATER RUNS CLEAR (about 2-3 gallons or 6-7
minutes).This will clean the system and clear air from
the lines. Additional flushing may be required in some
households.
NOTE: As air is cleared from the system, water may
spurt out of the dispenser.
Using the dispenser
without a water filter
You can run the dispenser without a water filter cartridge.
Your water will not be filtered.If you run the dispenser
without a water filter cartridge, keep the cartridge cap
and replace it in the base grille for future use.
1. Remove the water filter cartridge (See “Changing a
water filter cartridge” earlier in this section.) Then
slide the cartridge cap off the end of the filter
cartridge. DO NOT DISCARD THE CAP.
2. With the cartridge cap in the vertical position, insert
the cap into the base grille until it stops.
3. Rotate the cartridge cap to a horizontal position.
NOTE: The cartridge cap may not be even with the
base grille.
Ordering replacement filters
To order more water filter cartridges, call 1-800-253-1301
and ask for accessory Part #4392857 or contact your
authorized KitchenAid dealer.
Water Filtration and Monitoring System (cont.)