
Table of Contents
Section 5: Maintenance & Lubrication
Land Pride
9.
10.
11.
12.
Hydro-Drive Belt Replacement Instructions
Refer to Figure 5-12 & Figure 5-13:
1.Park unit on a flat surface. Stop engine and remove ignition key. Make sure blade engagement switch is in the down (OFF) position. Spread control levers fully apart.
!WARNING
Make sure engine and muffler are completely cooled before working on and around the
2.Disconnect negative battery cable.
3.Place deck height in the lowest position.
NOTE: Do not remove deck belt from the mower. Only remove it from the electric clutch pulley.
4.Remove deck drive belt (#8) from electric clutch pulley (#3) as outlined in steps 3 to 7 on page 37 under “Deck Belt Replacement Instructions”.
5.Release
6.Slide
7.Remove
8.Install new
9.Position the belt over the idler pulleys (#4) and slide the loosened idler pulley forward to take out any slack in the belt.
10.Check to make sure the
NOTE: Belt tension can be checked with a Belt Tension Gauge available at most auto parts stores.
11.Tighten the loose idler pulley (#4) until belt (#1) has
12.
13.
| 7 |
|
|
| 6 |
1 | 5 | 4 |
| 2 | 3 |
|
| 24901 |
| Drive Belt (#1) on |
| Engine Pulley (#2) |
| Deck Belt (#8) on |
| Clutch Pulley (#3) |
3 | 2 |
| |
| 1 |
| 8 |
| 24905 |
Hydro-Drive Belt Removal
Figure
Reference Figure 5-12 & Figure 5-13
1. | 6. | Access hole to idler | ||
2. | Engine pulley |
| pulleys | |
7. | Pump pulleys location | |||
3. | Electric clutch pulley | |||
| (Not shown for clarity) | |||
4. | Pump idler pulleys |
| ||
8. | Deck drive belt | |||
5. | Mounting bolts, | |||
|
|
idler pulley
38 Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers | 1/12/09 |