
Table of Contents
Land Pride
Section 3: Adjustments
Refer to Figure 3-9:
5.Set cutting height at 3 1/4” on the height indicator by placing the height adjusting stop in the 3” hole, and turning the height adjustment stop so that the flat side is against the stop handle.
6.Clamp the height adjusting stop against the stop handle. This will assure that the height will not move during the setting process. Otherwise, spring pressure from the deck lift springs will tend to pull the stop away from the handle.
Stop Handle |
Height Adjusting Stop |
24911 |
Cutting Height (Right Side Shown)
Figure
Refer to Figure 3-10 & Figure 3-11:
7.On both sides of the mower, loosen all nuts on the deck lift threaded rods and hardware on the adjuster until all deck lift chains are loose and the deck is sitting tightly on all three blocks.
Nuts | Deck Lift |
| Threaded Rod |
Nuts |
Foot |
Pedal |
Nut |
Deck Lift
Block
Height
Indicator Rod
Nut |
Deck Lift Chains
24911
Deck Level Adjustment (Right Side Shown)
Figure
Left Front
Deck Lift Chain
24897
Deck Lift Rod Adjustment (Left Side of Foot Pedal Shown)
Figure
24 Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers | 1/12/09 |