Land Pride
Section 3: Adjustments
Table of Contents
Deck Drive Belt Adjustment
The spindle belt remains in constant tension by means of a spring tensioned idler. The spring tension should be adjusted so that the belt does not slip under normal operating load conditions and may require readjusting as the belt stretches and wears. The belt should be replaced if it is excessively worn or damaged.
Refer to Figure 3-6 and Figure 3-7:
Check spring length to verify if belt is tensioned correctly. Installed spring length should be 4 3/4" +or- 1/8". Vary the spring length by adjusting the length of the eye bolt.
Hitch Pin
Remove Before Releasing Belt Tension
Eye Bolt (Adjust Length
To Vary Spring Tension)
Tension Idler
Engine RPM Setting
The Razor is designed so that the engine will run at 3600 rpm static pump load only. At this speed the hydraulic pumps are running at their maximum rated speed.
Deck Leveling & Height Adjustment
The mower deck has three areas that may need to be checked and adjusted periodically. Before considering any mower deck leveling adjustments, check that the tire air pressure is within the specified range.
!WARNING
Stop engine. Make sure blade engagement switch is in the down (OFF) position. Place control levers in park position before leaving machine.
Deck Level Adjustments
Leveling the deck must be done in the following order:
Spring |
Anchor |
Bracket |
(Turn Counterclockwise to Release Belt Tension)
Drive Belt Adjustment
Figure
23628
1.Check tire pressures to make certain they are properly inflated before leveling deck.
Tire Inflation Chart
Tire | Inflation PSI |
Drive Wheels | |
Caster Wheels |
2. Park the unit on a flat surface.
Refer to Figure 3-8:
3. | Raise deck fully up. |
4. | Position the blade cutting height at 3 1/4” by placing |
| 3" high deck support blocks under the deck edge in |
| three locations: |
| a. Place two of the 3" support blocks under the deck |
Excessive belt tension may lead to premature damage of belt and drive components and is also a safety hazard to the operator and bystanders. Not enough belt tension may also lead to premature belt damage due to excessive belt slippage.
IMPORTANT: Do not over tension the spring to compensate for a badly worn belt or pulley.
front edge |
spindles. |
b. Center the third 3" support block under the deck |
back edge. |
Blocks
24562
Deck Drive Belt Adjustment
Figure
23800
Blocking up Deck
Figure
1/12/09 | Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers | 23 |
