Canon 14EX, 24EX instruction manual Turning on the Power Switch, Fully Automatic Flash Shooting

Turning on the Power Switch

1

2

Turn on the power switch.

Set the power switch to <K> or <g>.

XThe flash recycling starts.

Check that the flash is ready.

The pilot lamp will light in red (fully charged) when the flash is ready.

XPressing the pilot lamp will fire a test flash.

To save battery power, the <g> Save Energy feature automatically turns off the MR-14EX/MT-24EX after 90 sec. of non-operation. To turn on the MR- 14EX/MT-24EX again, press the camera’s shutter button halfway.

A test firing cannot be fired while the camera’s operation timer 4or 0 is active.

The MR-14EX/MT-24EX’s settings will be retained in memory even after the power is turned off. To retain the MR-14EX/MT-24EX’s settings when you replace the batteries, replace the batteries within 1 minute after turning off the power.

Fully Automatic Flash Shooting

When the camera’s shooting mode is set to <V> (Program AE) or <U> (Full Auto), E-TTL II/E-TTL fully automatic flash photography will be enabled, making it as easy as normal AE shooting in the <V> or <U> mode.

1 2

Set the MR-14EX/MT-24EX to <ETTL>.

Press the <D> button to display <a>.

Take the picture.

Focus the picture and check that the <Q> icon is lit in the viewfinder.

XIf a standard flash exposure was obtained, the flash exposure confirmation lamp will light for about 3 sec.

18