27
You can set the flash output manually from full output at 1/1 to 1/64 output in
full-stop increments. The flash can be fired in one of three ways: 1. A and B fired
at the same output, 2. A and B fired at a different output, 3. Only A or B is fired.
You should first take a test shot to check the exposure.
1Select <q>.
Press the <D> button to
display <q>.
2Set the flash output.
Press the <a> button.
XThe flash output blinks.
Press the <h> or <i> button to set
the flash output.
X
Each time you press the button, the flash
output will increase/decrease by 1 stop.
Press the <a> button.
XThe flash output is displayed.
For step 2 above, follow the procedure below to set a different flash output for A and B.
1Press the <f> button to display <yl>.
2Select the flash tube/head.
Press the <
b
> button to select <
1
>, and the <
c
> button to select <
2
>.
3Set the flash output.
Press the <h> or <i> button to set the flash output.
Pressing the <i> button to set the flash output to “--” will set
only the other flash tube/head to fire.
XThe setting after 1/64 is “--”. The flash tube/head whose flash
output has been set to “--” will not fire.

q Manual Exposure

Firing A and B at the Same Flash Output
Firing A and B at a Different Flash Output
MR14_MT24_02.fm Page 27 Tuesday, December 20, 2005 4:36 PM