Canon 60, 65 instruction manual Troubleshooting, Power Source, Recording/Playback

Troubleshooting

If you have a problem with your camcorder, refer to this checklist. Consult your dealer

or a Canon Service Center if the problem persists.

Power Source

Problem	Cause	Solution
Camcorder will not turn	Battery pack is exhausted.	Replace or charge the	13
on.		battery pack.
	Battery pack is not correctly	Attach the battery pack	13
	attached.	correctly.
The camcorder switches	Battery pack is exhausted.	Replace or charge the	13
off by itself.		battery pack.
	Power save function has	Turn on the camcorder.	25
	been activated.
Cassette compartment	Battery pack is exhausted.	Replace or charge the	13
will not open.		battery pack.
	Cassette compartment cover	Open the cassette	16
	is not fully open.	compartment cover fully.
Cassette compartment	Battery pack is exhausted.	Replace or charge the	13
stopped during loading/		battery pack.
unloading.	The camcorder	Consult a Canon Service	–
	malfunctions.	Center.
LCD/viewfinder switches	Battery pack is exhausted.	Replace or charge the	13
on and off.		battery pack.
Battery pack will not	Battery packs will not	Charge the battery pack in	–
charge.	charge outside the	temperatures between 32 ºF
	temperature range of 32 ˚F	and 104 ºF (0 ºC and 40 ºC).
	and 104 ˚F (0 ˚C and 40˚C).
	Battery packs become hot	Wait until the battery pack	–
	with use and may not	temperature is below 104 ˚F
	charge.	(40 ˚C) and retry charging.
	The battery pack is	Use a different battery pack.	–
	damaged.

Recording/Playback

Buttons will not work.	Camcorder is not turned on.	Turn on the camcorder.	24
	Cassette is not loaded.	Load a cassette.	16
v flashes on the screen.	Cassette is not loaded.	Load a cassette.	16
k flashes on the	Battery pack is exhausted.	Replace or charge the	13
screen.		battery pack.
h flashes on the screen.	Condensation is detected.	See reference page.	144
“REMOVE THE	Camcorder stopped	Unload and reload the	16
CASSETTE” appears on	operating to protect the	cassette.
the screen.	tape.
The wireless controller	Camcorder and wireless	Change the remote sensor	77
will not work.	controller are not set to the	modes.
	same remote sensor mode.
	Batteries of the wireless	Replace the batteries.	20
	controller are exhausted.

148