Canon 700 manual NetWare Network Setup Procedures, See NetWare Print Service Settings, on p

3

Using a NetWare Network (Windows)

NetWare Network Setup Procedures

To use a NetWare network, it is necessary to perform the following procedures.

1	Connect the network cable. (See Chapter 1, “Before You Start Using This
	Machine,” in the PCL Printer Guide.)
	Connect the network cables in accordance to the directions specified in the PCL Printer Guide.
2	Specify the NetWare print service settings.
	(See “NetWare Print Service Settings,” on p. 3-3.)

Specify the NetWare print service settings, using one of the following methods:

•NetSpot (Canon software provided with the optional Network Kit III)

•NWADMIN or PCONSOLE (Novell software provided with NetWare)

3Specify the protocol settings. (See “Protocol Settings,” on p. 3-9.)

Specify the machine’s protocol settings on the computer using one of the following methods:

• NetSpot (Canon software provided with the optional Network Kit III)

• Remote UI (a web browser)

• An FTP client

4	Specify the computer settings for printing.
	(See “Setting Up a Computer for Printing,” on p. 3-11.)
	Connect each computer you want to use for printing to a NetWare network, and install the printer driver
	software.

IMPORTANT

•It is recommended that the Network Administrator perform steps 1, 2, and 3 above.

•To configure settings with software other than NetSpot, the TCP/IP protocol must be supported by your network environment.

•If you want to print on a NetWare network, disable the banner page. See ‘Using a Web Browser (Remote UI),’ on p.2-14.

3-2NetWare Network Setup Procedures