IMPORTANT

●Make sure that the scanner and your PC are both turned off when connecting the scanner to the PC.

●The factory default setting for the terminator of the scanner is set to ON as default. Be sure to turn off all terminators of the SCSI devices connected between the scanner and the PC.

Note

The factory default setting for the SCSI ID is “2”.

You can set the SCSI ID by using the DIP-switch provided on the rear side of the scanner. In the DIP-switch settings, the SCSI ID can be set to ON by turning the switch to the upper position, or OFF by turning it to the lower position.

Default Settings

(SCSI ID = 2)

12

ON

DIP Switch

Refer to the following table when setting the SCSI ID. If there are other SCSI devices connected to or inside the PC, make sure to set a unique ID for the scanner.

SCSI ID

SW1

SW2

2

OFF

OFF

 

 

 

3

OFF

ON

 

 

 

4

ON

OFF

 

 

 

5

ON

ON

 

 

 

20Installing the Scanner