2
Notes
Need
Photo 3
Photo 4
Photo 5
Photo 6
Photo 7
WX Technical Instructions
Step 3
Just like the HP4 cartridge, the two halves of the cartridge can now be separated.
(See Photo 3)
Step 4
Set the hopper aside. If you have a waste hopper fixture,set the waste hopper in the fixture. If not, place the waste hopper on the table.
(See Photo 4)
Step 5
The drum axle is a metal rod that goes through the center of the drum end to end. On the large gear end of the axle is a small white plastic retaining ring. Using a drift punch and a hammer, tap directly on the shaft (large gear side) and drive it out
the other end. | (See Photo 5) |
NOTE: Make sure you don’t lose the retain- ing ring. The ring fits into a groove on the drum shaft to hold the shaft in position. Repeated removal will wear this ring and the ring will no longer snap into position. If the ring does not snap, replace it.
Step 6
Remove the drum, blow off excess toner with compressed air and clean with iso- propyl alcohol. Wrap the drum in a protec- tive paper or cloth and set it aside in a dark,
protected place. | (See Photo 6) |
NOTE: We were able to use the OEM drum once after the Oem cycle with no loss in density, however, you may choose to recoat or replace the drum after the first recharge.
Step 7
Remove the primary charge roller from its clips. Clean clips with isopropyl alcohol and a cotton swab. Inspect the primary charge roller for damage. Clean the pri- mary charge roller with a mild soap and water and set it aside.
(See Photo 7)
NOTE: We have had no problems using the OEM primary charge roller three cycles in mild weather climates.
