WX Technical Instructions
Photo 38
Step 38
Reinstall the toner paddle bar felts and the bar gears that hold them in. Then install toner sensor bar.
(See Photo 38)
Photo 39
Step 39
Put a little fresh toner on the doctor blade and reinstall.
(See Photo 39)
Photo 40
Step 40
Place the mag roller bushing, mag roller bearing, and the mag roller stabilizer back on the mag roller. Install mag roller back onto toner hopper.
(See Photo 40)
Photo 41
Step 41
Reinstall all the gears on the toner hop- per.
(See Photo 41)
|
|
| Step 42 |
|
|
| Now install the gear side end cap, align- |
Photo 42 |
|
| |
|
|
| ing the “flat sided shaft” of the magnet |
|
|
| with its “D” shaped hole and the position- |
|
|
| ing pins through the mag roller stabilizer |
|
|
| holes and then press down. Install two |
|
|
| Phillips head screws. Align the metal bias |
|
|
| strap to the plastic pin next to the doctor |
|
|
| blade and press into position so that it |
|
|
| contacts the doctor blade. |
|
|
| (See Photo 42) |
|
|
|
|
9
Notes
Need help with a particular remanu- facturing problem?
Call the Technical Resource Center from 8am - 5pm PST: 800 394.9900
