Setting
57
Setting
Standbymode
This function is available when operating the projector
via network.
Network .... Supply the power to the network
function even after turning off the
projector by pressing the POWER
button on the remote control unit.
You can turn on/off the projector via
network, modify network environment,
and receive an e-mail about projector
status while the projector is powered
off.
Eco ............ Select Eco when you do not use the
projector via network. The projector’s
network function will stop when turning
off the projector, you can not turn on the
projector via network.
Refer to the user’s manual of “Network Set-up and
Operation”.
Note:
• When selecting Network, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.• When Eco is selected and the projector is in Standby mode, the communication of RS-232C serial port is not available.
This function allows you to change the setting of the P-
timer and execute it.
Select one of the following options:
Countup ........... The P-timer display 000:00 appears
on the screen and the count up starts
(000:00-180:00)
Countdown ...... The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer ................. Use the Point ▲▼ buttons to set the
Timer (1-180Min). Timer is available
in Count down only. Factory default
velue is 10 Min.
Start .................. It executes the count up or count
down function. Press the OK button
at Start and the indication changes
into Stop. To stop Countup or
Countdown, press the OK button
at Stopon the screen menu, then
the indication changes into Restart.
Press the OK button at Restart to
resume Countup or Countdown.
Reset ................. Reset the P-timer values.
Press the OK button at Reset to
return to the following value;
Countup ... "000:00"
Countdown ... Timer that you set
Exit .................... To exit the P-timer operation.
P-TIMERP-timer display
StoporCanceltheP-timerviaRemotecontrolunit
To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
P-timerX: disabled O: enabled
*1 When switch the STANDBY MIC OUT function
On in Standby mode status, only MIC volume
can be output.
Eco Network
Serial command XO
Network X O
Monitor Out X O
Audio Out X X *1
Direct power on O O