70
Problem: – Solutions
Nopower – Plug the power cord of the projector into the AC outlet.
– See if the POWER indicator lights red.
– Wait until the POWER indicator stops blinking to turn on the
projector again. The projector can be turned on after the
POWER indicator turns red. See page 21.
– Check the WARNING indicator. If the WARNING indicator lights
red, projector cannot be turned on. See page 70.
– Check the projection lamp. See page 68.
– Unlock the Key lock function for the projector. See page 60.
Theinitialdisplayisnotshown.– Make sure Off or Countdownoff are not chosen at display
function. See page 53.
Theinitialdisplayisnotsame– Make sure User or Off are not chosen at Logo (select)
asthedefaultset.function. See page 53.
Inputsignalswitchesautomatically.
– Make sure Auto input function is adjusted properly.
(ordoesnotswitchautomatically)
See page 52.
Whentheprojectorisonand
– That is the Filter warning icon. See page 60.
youpresstheinputsource
buttons,aniconotherthan
theLampmodeiconappears.
AniconotherthanInputmode – That is the Lamp replacement icon or the Filter warning icon.
orLampmodeiconappears.See page 68 or 60.
Imageisoutoffocus. – Adjust focus of the projector. See page 26.
– Provide proper distance between the projector and the
projection screen. See page 15.
– Check the projection lens to see if it needs cleaning.
See page 67.
– Moving the projector from a cool to warm place may result in
moisture condensation on the projection lens. In such cases,
leave the projector off and wait until condensation evaporates.
ImageisLeft/Rightreversed. – Check the Ceiling/Rear function. See pages 38,40,48,50.
ImageisTop/Bottomreversed. – Check the Ceiling function. See pages 38,40,48,50.
Pictureisnotbrightenough. – Check if the Contrast or Brightness is adjusted properly.
See pages 36, 45.
– Check if Imagemode is selected properly. See pages 35,44.
– Check the Lamp mode function. See pages 28, 59.
– Check the LAMP REPLACE indicator. If it lights, the end of lamp
life is approaching. Replace the lamp with a new one promptly.
See page 68.
Before calling your dealer or service center for assistance, check the items below once again.
– Make sure you have properly connected the projector to peripheral equipment as described on
pages 17-19.
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When the projector does not project an image from the connected computer, restart the computer.
Appendix

Troubleshooting