Carrier Access Terminal Server Router Back-to-Back with PPP, Boulder Router in Slot, Command

Quick Start Guide

Back-to-Back with PPP

Back-to-Back with PPP

The following configuration will set up two Routers back-to-back with PPP.

Boulder Router in Slot 1

Command

set 1 default disconnect a:1

disconnect 1

set a:1:all type data connect a:1:all 1:1:1

rename 1 "LocalUnit" "Boulder"

rename 1 "RemoteUnit" "wan1"

set 1:1 ip address 1.1.1.1 255.255.255.0

set 1:1 phy auto

add 1 "wan1" static ip network 2.2.2.0 255.255.255.0 1

set 1:1:1 encapsulation ppp set 1 "wan1" trunk 1

reset 1

Description

Set Router to default settings

Disconnect all connections to the T1 on the Controller (slot a)

Disconnect all connections to the router in slot 1

Set the T1-1 of the Controller, Type to Data

Connect all of T1-1 to the Router that is in slot 1

Rename the Axxius 800 from "LocalUnit" (default) to "Boulder" (LAN)

Rename WAN #1 from "RemoteUnit" (default) to "wan1"

Set the ethernet IP address, in the conventional IP address format. (Router LAN)

Set the Physical Specifications to auto-negotiate

Adds a static IP network (route) to the WAN interface

Set the encapsulation on trunk 1 to PPP

Set the WAN interface named "wan1" to be mapped to trunk 1

Reboot the router, to enable all configurations set

Terminal Service Router - Release 1.3 11