Carrier Access Terminal Server Router Back-to-Back with Multi-Link PPP, Boulder Router in Slot

Quick Start Guide

Back-to-Back with Multi-Link PPP

Back-to-Back with Multi-Link PPP

The following configuration will set up two Adit 600 Routers back-to-back with Multi- Link PPP.

Boulder Router in Slot 1

Command

set 1 default disconnect a:1

disconnect 1

set a:1:all type data connect a:1:all 1:1:1 connect a:2:all 1:1:2

rename 1 "LocalUnit" "Boulder"

rename 1 "LocalUnit" "Boulder"

set 1:1:1-2 multilink group 1

rename 1 "RemoteUnit" "wan1"

set 1:1 ip address 1.1.1.1 255.255.255.0

add 1 "wan1" static ip network 2.2.2.0 255.255.255.0 1

set 1 "wan1" trunk multilink group 1

reset 1

Description

Set Router to default settings

Disconnect all connections to the T1 on the Controller (slot a)

Disconnect all connections to the router in slot 1

Set the T1-1 of the Controller, Type to Data

Connect all of T1-1 to the Router that is in slot 1

Connect all of T1-1 to the Router that is in slot 1

Rename the Adit 600 from "LocalUnit" (default) to "Boulder" (LAN)

Rename the Adit 600 from "LocalUnit" (default) to "Boulder" (LAN)

Rename the Adit 600 from "LocalUnit" (default) to "Boulder" (LAN)

Rename WAN #1 from "RemoteUnit" (default) to "wan1"

Set the Ethernet IP address, in the conventional IP address format. (Router LAN)

Adds a static IP network (route) to the WAN interface

Set the WAN interface named "wan1" to be mapped to trunk multilink group 1

Reboot the router, to enable all configurations set

Terminal Service Router - Release 1.3 13