FOUR SEASONS™ III (OUTSIDE USA INSTALLATION) 
OUTSIDE USA - SECONDARY SUPPORT ♦PREPARING THE SWITCH HOUSING
Step 5. Hold the switch housing close to the fan and connect the motor plug to the switch housing socket. The connectors are keyed to ensure correct alignment during installation - Do not force!
Step 6. Locate the blue and white LIGHT wires in the switch housing. Make sure they are NOT connected.
Step 7. Check the tightness of the Cable Clamp & Screw. (The clamp should not slip along the cable.)
Step 8. Tape completely over the end of the Cable Clamp and the end of the Secondary Support Cable with electrical tape.
TAPED OVER
CABLE CLAMP
& SCREW
Step 9. Pull the cable through the other side of the fan to snug the cable clamp. This makes it easier to install the switch housing.
Step 10. Remove the three mounting screws from the switch housing plate. (Keep them for the next step).
CABLE
CLAMP & SCREW
SECONDARY
SUPPORT CABLE
NYLON
STOP 
SWITCH
HOUSING
SWITCH
HOUSING
CONNECTOR
(SOCKET)
MOTOR
CONNECTOR
(PLUG)
SWITCH
HOUSING
PLATE
MOUNTING
SCREW
(3)
OUTSIDE USA - SECONDARY SUPPORT ♦SWITCH HOUSING INSTALLATION
Step 11. Position the switch housing assembly on the switch housing plate and align the holes in the switch housing with the holes in the plate. Secure the switch housing assembly by reinstalling the three screws removed in the previous step.
CAUTION! Do not pinch wires between the switch housing assembly and the plate.
MOUNTING
SCREW
(3)
11
