Saving Keyboard Setups to Registration Memory

To save a setup to registration memory

1.Press bp.

Lights

Bank number

2.Configure the tone, rhythm, and other settings you can to include in the setup.

3.Press bs to select the bank you want.

Each press of bs cycles through the bank numbers.

Bank 4

You also can select a bank by holding down bs as you use the br (10-key) number buttons to enter a bank number.

4.While holding down cn, press a button from bt to cm to select an area.

This will save the settings you configured in step 2 into the applicable setup.

If there is anything already stored in the setup, it will be replaced (deleted) by the new setup.

S t o r e

Stored in Setup 4-1

To recall a setup from registration memory

1.Press bs to select the bank that contains the setup you want to recall.

Bank 6

2.Use buttons bt to cm to select the area whose setup you want to recall.

This will recall the registration memory setup and automatically configure the Digital Keyboard settings accordingly.

R e c a l l

Setup 6-1 recalled

Notes currently being sounded by the keyboard may stop if you recall a setup that causes a change in octave shift (page E-16). To keep this from happening, either select a setup that does not cause a change in the octave shift setting, or hold down the pedal (which will cause notes currently being played to be sustained).

Saving registration Data on an External Device

• SD memory card (CTK-5000 only) (page E-61)

• Computer (page E-68)

Maintaining Data in Registration Memory

After you save data in registration memory, it will remain there as long as power is supplied to the keyboard. However, if you disconnect the AC adaptor when there are no batteries loaded, data in registration memory will be deleted.

Tips for Maintaining Data

Use both batteries and the AC adaptor together.

Make sure that batteries with sufficient power are loaded whenever you disconnect the AC adaptor.

Connect the AC adaptor to the keyboard and plug it into a power outlet before replacing batteries.

Before connecting or disconnecting the AC adaptor or replacing batteries, first press 1 to turn off power.

English

E-47