Connecting the Camera to Your Computer and Saving Files
IMPORTANT!
•The camera does not support operation with Mac OS X 10.0. Operation is supported with Mac OS 10.1, 10.2, 10.3, 10.4, 10.5, and 10.6 (using the OS standard USB driver) only.
.To connect the camera to your computer and save files
1.Turn on the camera and press [MENU].
2.On the “Set Up” tab, select “USB” and then press [6].
3.Use [8] and [2] to select “Mass Storage”, and then press [SET].
4.Turn off the camera and then use the USB cable that comes with the camera to connect it to your Macintosh.
USB port | USB cable (included with camera) |
Large connector
[USB/AV] port
Terminal cover
Small connector
Making sure that the 6 mark on the camera is aligned with the 4 mark of the USB cable connector, connect the cable to the camera.
The camera will turn on automatically and battery charging will start (page 19).
•The camera may not turn on automatically in the case of certain computer models or connection conditions. If this happens, press [ON/OFF] (Power) to turn on the camera.
•Make sure that you insert the cable connector into the USB/AV port until you feel it click securely into place. Failure to insert the connector fully can result in poor communication or malfunction.
148Using the Camera with a Computer