10.Press [SET].

•The approximate number of recordable CS images will appear on the monitor screen.

Number of recordable CS images (If you are not performing Prerecord CS, the allowable continuous shutter time also is displayed.)

Remaining snapshot memory capacity

11.Half-press the shutter button.

This will cause the camera to start pre-recording images.

•The camera will not emit a shutter sound when you half-press the shutter button while Prerecord CS is selected.

•If you release the half-pressed shutter button before pressing it the rest of the way down, all of the pre-recorded images currently in the buffer will be deleted.

12.When you are ready to shoot, press the shutter button the rest of the way down.

This will record the images in the pre-record buffer and start recording new images in real-time. Images continue to be shot as long as you keep the shutter button depressed.

13.Real-time shooting will stop when you release the shutter button or after the maximum number of shots is reached.

NOTE

•Note the following when selecting a High Speed CS speed (fps) setting.

–Use a higher High Speed CS speed (fps) setting when shooting a fast-moving subject.

–Use a slower High Speed CS speed (fps) setting when shooting a slower-moving subject.

•Note the following when selecting a High Speed CS maximum number of shots setting.

–The greater the number of shots, the longer it takes to save them after shooting is complete.

•Note the following when specifying a Prerecord CS shots setting.

–A setting that results in a Prerecord CS operation that takes at least 0.3 seconds is recommended because there is a minimal lag from about 0.1 seconds to

0.3 seconds between the point you decide to shoot and the point that the shutter button is fully depressed.

53

Snapshot Tutorial