IMPORTANT!

•While the “Anti Shake” setting is “ Auto” or “ Camera Shake”, half pressing the shutter will cause the

camera to vibrate and emit an operation sound. This is normal and does not indicate malfunction.

•ISO sensitivity, aperture, and shutter speed do not appear on the monitor screen when you half-press the shutter

button while “ Auto” is selected for Anti Shake. They do appear along with the image that is displayed immediately

after you record it so you can check them.

•Imege Blur will not work unless the ISO setting (page 141) is set to “Auto”.

•Shooting with Anti Shake can cause an image to appear somewhat coarser than normal and can cause slight deterioration of image resolution.

•Anti Shake may not be able to eliminate the effects of hand or subject movement when movement is severe.

•You can also use Camera Shake to reduce the effects of hand movement only while recording a movie. The effects of subject movement are not limited (page 99).

•Camera Shake may not work well with a slow shutter speed. If this happens, use a tripod to stabilize the camera. Note that the CCD shift type camera shake correction

feature does not operate while you are recording on a tripod. Select off for the “Anti Shake” setting or select “ Image Blur”.

•The camera sometimes performs an automatic noise reduction operation to reduce digital noise in images recorded under certain lighting conditions. This operation causes the camera to take longer than normal to store the image and be ready for the next shot.

•Only the “ Camera Shake” setting can be enabled in the S Mode (Shutter Speed Priority AE) and M Mode

(Manual Exposure) (page 91). At shutter speeds slower

than four seconds, “ Camera Shake” becomes disabled in the S Mode and M Mode.

134

ADVANCED SETTINGS