Casio DT-X11 Series, handheld terminals manual Function Keys

10	Function Keys	These keys can be assigned any function other than barcode reading.
		The following are the initial default settings.
		F1	: Deletes one character to the left.
		F2	: Inputs a hyphen (-).
		F3	: Inputs a period (.).
		F4	: Toggles to switch between numbers and alphabets.
11	IR Port	This port is used for IR communication with another Handheld
		Terminal or Bridge Satellite Cradle.
12	Power Contacts	Contact point for supplying power from Bridge Satellite Cradle and
		Cradle-type Battery Charger.
13	CLR Key	Press to clear all key inputs.
14	Fn Key	Press this key and then a function key or number key to configure
		settings or to run previously registered applications.
15	PC Card Slot	For insertion of a separately available PC card.
16	USB Port	For connection to a computer or other device using a USB cable.
17	Headset Jack	For connection of a commercially available headset (2.5mm).
18	Battery Pack Cover Lock	Slide these switches to lock and release the battery pack cover.
	Switches
19	R Trigger Key	Press to perform a code read operation. This is also pressed to perform a
		full reset.
20	L Trigger Key	Press to perform a code read operation. This is also pressed to cancel a
		full reset.
21	Wrist Strap Hole	Connect the wrist strap here.
22	C-MOS Imager (C-MOS	Reads 1D bar codes and 2D codes.
	Imager models only)
	Reader Port (Laser Scanner	Reads 1D bar codes.
	models only)
23	Reset Switch	Press to reset the Handheld Terminal.
24	CF Card Slot Unit Terminal	For connection of a separately available CF Card Extension Unit.
25	Battery Pack Cover	Covers the compartment that holds the battery pack.

11