Casio IT-2000 installation manual 2 Error codes and error messages

	Error Code		Error Message	Description	Remedy
	categ	Detai
Er	0x04	0x00	ReadOnlyFileAccessError	Write is specified to read-only-file.	Change the file attribution for
ror					write.
	0x05	0x00	CommunicationError	Communication error.	See note 1.
	0x05	0x03	SpawnError	Spawn error.	See note 1.
	0x05	0x04	CommandTimoutError	Command timeout error.	See note 1.
	0x05	0x05	ErrorOpeningErrorLogFile	Fail to open log file.	Check if the path name of log file
					is correct.
	0x05	0x06	OptionError	Option error.	Check if the selection of operation
					is correct.
	0x05	0x07	StartupError	Startup error.	Check if other application is using
					the COM port.
	0x05	0x08	OpenError	Open error.	See note 1.
	0x05	0x09	ListenError	Listen error.	See note 1.
	0x05	0x0A	AcceptError	Accept error.	See note 1.
	0x05	0x0B	NotEnoughMemoryToExecuteProcess	Memory is not enough.	Close other applications first.
	0x05	0x0C	ArgumentListTooLargeForTheProcess	Process is too long.	See note 1.
	0x05	0x0D	InvalidModeForTheProcess	Child-process ends illegally.	Check the operation method.
	0x05	0x0E	ProcessTerminatedNormally	Child-process ends normally.	Normal end.
	0x05	0x0F	NoiseError	Communication noise error.	See note 1.

Table 4.2 Error codes and error messages

Note:

1. First make sure the connection of each option is complete and each component is powered properly. Next, restart the system and execute the process again. If the same error occurs again, reduce the baud rate before retrying. If normal operation cannot be achieved even after making the above adjustments, contact your nearest support/technical center.

2.The file could not be properly accessed. Check if the file can be properly accessed or if the disk is full.

25