2.3Installation Method
This section describes the installation and setup procedures that must be performed before I/O Box and PC operations are started. The following diagram shows a flow of the setup procedure.
Fig.2.6 Installation flow of
(If Master I/O Box is used) Mount SCSI Board in the PC and install the SCSI driver
Install Upload/Download
Utility in the PC.
Turn OFF the power of the
PC.
Set the DIP switch of I/O Box.
Connect each cable between I/O Boxes.
Connect cable between the PC and I/O Box.
Connect AC adaptor for each I/O Box.
Turn ON the power of all the I/O Boxes.
Turn ON the power of the PC.
Star up the Upload/Download Utility and set the environment.
Note:
For information about the installation procedure of the Upload/Download Utility refer to the Upload/Download Utility Manual.
For information about the I/O Box setup refer to Chapter 2.3.1 “Setup of Satellite I/O Box”, Chapter 2.3.2 “Setup of Master I/O Box”, and Chapter 2.3.3 “Setup of Satellite I/O Box to
Master I/O Box”.
For information about the setup of Upload/Download Utility environment refer to Chapter 2.3.4 “Setup of PC”.
8
