Casio PX720, PX720C E-25, (2-1), (2-3), (2-2), (3-2), A (3-1)

			Assembling the Stand
PREPARATION		2. Perform the following steps to attach side
• Before starting assembly of the stand, divide the		panel A to the digital piano.
polystyrene foam packing material K into the sections as
shown in the illustration below. After dividing up the		IMPORTANT!
material, you should end up with a total of six pieces		IMPORTANT!
material, you should end up with a total of six pieces		• When inserting the corner of the side panel into the
named K-(a), K-(b), and K-(c), which you will use while		• When inserting the corner of the side panel into the
named K-(a), K-(b), and K-(c), which you will use while		bracket on the side of the digital piano in step (2-3)
assembling the stand.		bracket on the side of the digital piano in step (2-3)
assembling the stand.		below, take care to avoid damaging the side panel corner
• If you do not have any packing material available for		below, take care to avoid damaging the side panel corner
• If you do not have any packing material available for		(). Never try to insert the side panel into the bracket
some reason, use a magazine or some other thick item.		(). Never try to insert the side panel into the bracket
some reason, use a magazine or some other thick item.		without first tilting the side panel at an angle as instructed

		in step (2-2). Doing so creates the risk of damage of the
		side panel corner.
		(2-1)	On side panel A, locate the corner that has a metal
			piece attached to it, and then insert that corner
			into foam piece K-(b).
		(2-2)	Tilt side panel A slightly as indicated by the
			arrow in the illustration.
		(2-3)	Keeping side panel A tilted at an angle, carefully
K-(a)			insert the opposite corner () into the bracket on
K-(a)			the side of the digital piano.
K-(b)
			(2-1)
K-(c)		(2-3)	(2-2)
		(2-3)	(2-2)
1. Place the digital piano onto the two K-(a)		Bracket
1. Place the digital piano onto the two K-(a)			A
foam pieces.			K-(b)
Bottom of the digital piano			K-(b)
Bottom of the digital piano
Bracket		3. Keeping side panel A tilted at an angle, align
		3. Keeping side panel A tilted at an angle, align
*	K-(a)	the side panel with side of the digital piano.
	K-(a)	(3-1)	Push side panel A in the direction indicated by
		(3-1)	Push side panel A in the direction indicated by
			the black arrow in the illustration to align the side
			panel so there is as little space as possible between
K-(a)			its top edge A and the bottom of the top panel of
K-(a)			the digital piano ().
* Make sure that the edges of the brackets on either		(3-2)	After alignment is complete, stand side panel A
* Make sure that the edges of the brackets on either			straight up so it is firmly against the side of the
side of the digital piano are positioned at the top of			digital piano.
the foam pieces.
		Top panel of the digital piano

(3-2)A (3-1)

K-(b)

IMPORTANT!

• When performing step (3-1) above, make sure that you position side panel A so its top edge reaches the bottom of the digital piano top panel. If it does not, you will not be able to stand side panel A straight up in step (3-2).

B	E-25