Assembling the Stand

4. Perform the following steps to secure the side panel to the digital piano.

(4-1) Press downwards on side panel A to ensure that it is inserted as far as it will go into the bracket on the side of the digital piano.

(4-2) Use the D screws to secure side panel A to the digital piano.

(4-1)(4-2)

D

Bracket

A

5. Insert foam piece K-(c)under side panel A as shown in the illustration.

A

K-(c)

IMPORTANT!

•The foam piece should be located directly under the two screw holes () in the side panel.

6. Repeat steps 2 through 5 to attach side panel

Bto the other side of the digital piano.

7. With the speaker box C laying on its side as shown in the illustration, secure side panels

Aand B to the speaker box C. Secure the side panels using four screws D.

•Align the screw holes of the speaker box C with the screw holes of the side panels as you install the screws D.

•Partially tighten the screws on one side of the speaker box C and then fully tighten the screws on the other side.

•Next, fully tighten the screws that you partially tightened.

B

D

A

C

D

•You can also install the speaker box C so it faces towards the back of the stand.

8.After ensuring that all of the screws are fully tightened, remove the packing material and

stand up the stand.

•After standing up the stand, cover each of the eight screws you have installed up to this point with screw caps E.

9.Attach the brackets I to the pedal unit F, and temporarily secure them with screws G.

G

G

I-(b) F

I-(a)

If you plan to locate the digital piano against a wall, proceed to step 10 on page E-28.

E-26

 

B