Assembling the Stand
To tighten the joint connector and screw
(1)Rotate the screw counterclockwise about three turns to ensure that the screw is in the center of the joint connector.
(2)Slowly rotate the screw clockwise and confirm that it tightens without resistance. If you feel any resistance, it means that the screw is not engaging properly with the joint connector. Rotate the screw counterclockwise again and try to get it to engage properly.
(3)If you experience problems getting the screw to engage properly, use a screwdriver to rotate the joint connector 180 degrees. Next perform steps (1) and (2) again to engage the screw from the screw hole on the other side.
*Forcibly tightening a screw while it is not engaged properly can strip the threads of the screw and joint connector, making it impossible to tighten the screw.
Locating the Stand against a Wall
•Perform steps 1 through 9 starting on page
10. Loosen the bracket screws at the bottom of the stand’s side panels A and B to create a gap between the side panels and corner brackets as shown in the illustration.
BA
Gap
11. As shown in the illustration, insert the pedal unit brackets into to the gaps you created in step 10.
12. Securely tighten the screws G that you temporarily tightened in step 9.
•Cover the screw heads with the caps J.
J
G
|
| B |
|
|