5 What you should do next depends on whether or not [ENTER] is displayed at the far right of the setting you are configuring (the one that is highlighted).
If [ENTER] is displayed:
a.Press the [ENTER] key.
b.On the submenu that appears, use [T] and [S] to move the highlighting to the setting you want to select.
Example: The following is the submenu that appears when “Display Sequence Setup” is selected in step 2, above.
c.Press the [ENTER] key.
d.To return to the Viewer setup menu, press the [ESC] key.
If [ENTER] is not displayed:
Press the [W] or [X] key to select the setting you want (so its button is ).
6 Repeat steps 4 and 5 to configure other settings, if you want.
7 After all the settings are the way you want, press the [MENU] key to exit the Viewer setup menu.
To restore all settings on the Viewer setup menu to their initial factory defaults
1
2 Press the [T] key to move the highlighting to “USB” and then press the [ENTER] key.
3 Press the [T] key once to move the highlighting to “Setup” and then press the [ENTER] key.
zThis will display the Viewer setup menu.
4 Press the [T] key to move the highlighting to “Initialize Viewer Setup” and then press the [ENTER] key.
zThis displays the dialog box shown below.
42