Connecting to a USB Device while the Data Projector is On

If you connect a USB device to the Data Projector’s USB port while it is turned on, it will perform one of the following operations (depending on its current plug-and-play setting).

When plug-and-play is enabled:

When this type of device is

The Data Projector does this automatically:

connected:

 

USB memory device or USB card

Starts up Viewer (page 27) and projects the Viewer screen.

reader with memory card loaded

 

 

 

YW-2 Wireless Adapter

Starts up Wireless and projects the Wireless screen.

 

 

YC-400/YC-430 Document Camera

Starts up the YC Camera application (page 47) when the

 

Document Camera is turned on and projects the YC Camera

 

application screen.

 

 

When plug-and-play is disabled:

In this case, the image that is currently being projected does not change. However, Viewer, Wireless, or the YC Camera Application will start up in the background, depending upon the type of USB device that is connected to the Data Projector.

Changing the Input Source while a USB Device is Connected

On the Data Projector’s remote controller, press the [INPUT] key to change the input source. Each time you press the [INPUT] key, the Data Projector will check the RGB terminal, VIDEO terminal, and USB port for an input signal. If it finds a signal, it will select it as the input source automatically and project its contents.

9