CDA PC85SC user manual Ab Freezer Compartment, Storing Food in Freezer Compartment

Ab Freezer Compartment

3How to use the icemaker

The ice maker can produce 8 cubes at a time. The icemaking capacity depends on ambient temperature, frequency of door openings and inner temperature of freezer compartment.

>After the refrigerator is installed and started, allow 24 hours

NOTE for the freezer compartment to cool down before the initial icemaking.

For initial icemaking, discard the first batches of ice cubes produced. This is also applicable If the icemaker has been idle for a long period of time. Arrange ice cubes

in the ice bin from time to time to ensure the maximum storage. Eight ice cubes are produced at a time. It’s normal that some of them may get frozen to each other.

If this is your first icemaker

You may hear some creaking noise when the icemaker is running. That’s normal.

5If ice cubes have been stored too long

Ice cubes may get gray and off-taste. Please discard old ice cubes and clean the ice bin with warm water regularly. Before replacing the ice bin, make sure it cools down to ambient temperature and air dries, or otherwise ice cubes may stick to other parts of the icemaker and reduce ice production.

6If ice compartment is not used during winter

During winter months, if you don’t need the icemaker for a long time, please take out ice cubes from the ice compartment, and wash the bin with warm water, then replace it back after wiping it dry. Shut off the water supply to the refrigerator

7If icemaker is not used

If you don’t need the icemaker , take down the icemaker shelf and it can be used as freezer room.

Adjustable partition wall of freezer drawer

A movable partition wall is provided in the freezer drawer to divide the drawer into two parts. You may move the partition wall right or left to meet your storage needs.

Replacing the Light Bulb
Bulb specifications: 220V~, 25W
Socket: E14 (DO NOT use a bulb over 25W)
To replace the light bulb:	Freezer	Screw hole
Unplug the appliance.
1 Remove the front screw with a
screwdriver.	light	Square
2 To remove the light cover,
press the stopper at front out		hole
	socket
of the square hole.
3 Pull the cover forward until
the retainer is separated		Stopper
from the square hole.
Turn the bulb anticlockwise and remove.
Replace a bulb of the same
specifications in the reverse sequence
of removal.		Retainer

To replace the light cover: Replace the retainer

into the square hole and then press the shield front freezer bulb until the stopper is locked in the square

hole. Replace and tighten the screw.

Storing Food in Freezer Compartment

Allow warm foods to cool down before	Store food in smaller packages. This will
putting them into the freezer.	make it easier to freeze the food and
	provide better quality when the food is
	thawed. It’s recommended that each
	package should not exceed 2.5kg.

Wrap food before storing. Make sure	The food package should indicate
the wrappings are dry to prevent them	information such as type of food, date
from sticking to each other. The	of storage and expiry date.
wrapping materials used should be
odourless airtight, leak-proof, nontoxic
and environmental friendly to prevent
unpleasant odour or food deterioration.

Once thawed, food cannot be returned	Do not put too much fresh food in your
to the freezer unless it has been	freezer. The freezing capacity (as
cooked. Always get frozen food from	indicated in the Technical Data sheet)
the freezer for thawing according to	should be observed.
actual needs.

26

25