CDA PC85SC user manual Initial Use

Preparation

Removing & Replacing Freezer Door Handle

Get 2 fasteners out of the accessory bag and place them in 2 reserved holes in the freezer door. Install a handle by attaching the reinforcing plate to the fasteners and then pushing the handle into its place. To remove the handle, push it to the right.

Fastener

Reinforcing plate

Installing wine shelf

Open the door of refrigerator compartment. Take out the food shelf at the upper left corner. Place the glass shelf downward on a table. Then take out the wine shelf from the delicatessen drawer at the bottom. Hold the wine shelf at both ends, attach it to the food shelf (as (1) shown below) and then push it in place (as (3) shown below).

Initial Use

Connect the appliance to the power supply.

The appliance has a backup memory and the settings before a power interruption will be stored.

(See Backup Memory section on Page 18 for details)

Operation Modes

>Once the AI mode is selected, there is no need to make any adjustment within a prescribed range of temperature, notwithstand-

NOTE ing the changes in ambient temperature.

You can select one of the following operation modes.

(1)AI: Unless otherwise required, it is recommended that the AI mode is used. Tap the AI button and the indicator will illuminate. The appliance will start an automatic operation. (See the AI Mode section on Page 15)

(2)Manual: Alternatively, you can adjust the inner temperature by means of the temperature control button. (See the Temperature Setting & Regulation section on

Page 17)

Loading the refrigerator

The inner compartment will be cold enough and ready for food storage after a couple of hours of non-load operation.

>When the temperature setting is adjusted, it takes some time to reach the desired inner temperature. The period will be longer or shorter, depending on

NOTE the ambient temperature, amount of food and how often the door is opened.

13 14