CDA RC 9000 installation instructions Enamelled parts

Models: RC 9000

1 44
Download 44 pages 8.37 Kb
Page 22
Image 22

Enamelled parts

All the enamelled parts must be cleaned with a sponge and soapy water only or other non-abrasive products.

Dry preferably with a microfibre or soft cloth.

Stainless steel, aluminium, painted parts and silk- screen printed surfaces

Clean using an appropriate product. Always dry thoroughly.

Stainless steel surfaces: can be cleaned with an appropriate stainless steel cleaner.

IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abra- sion. You are advised to use a soft cloth and neutral soap.

CAUTION: Do not use abrasive substances or non-neutral detergents as these will irreparably damage the surface.

Changing the oven light

1.Disconnect the electrical power supply (for example, by switching off the main power switch).

2.Unscrew the light cover

3.Fit a new bulb.

4.Refit the cover.

Note:

Use only bulbs designed to resist up to 300°C with the following characteristics: 230 V, type E14 and same power (check watt power as stamped in the bulb itself) of the replaced bulb.

22

Page 22
Image 22
CDA RC 9000 installation instructions Enamelled parts