Manuals / Brands / Computer Equipment / Server / Celestron / Computer Equipment / Server

Celestron AP8000 • 4-2.Motherboard, Spacers, Install the, Baseboard, Screws

1 44

Download 44 pages, 1.11 Mb

IV. Hardware Setup

• 4-2. Motherboard

Motherboard

Spacers

Place four spacers in the areas circled on the chassis.

Spacer

Setup Hardware .IV

Motherboard

Place and tighten three captive nuts in the corner locations as circled.

Install the

Baseboard

A metal baseboard is required to add stability to the motherboard. A rubber pad is placed between the metal board and motherboard to prevent shorting. Align the rubber pad over the metal baseboard so that the holes match. Align the XG-DLS motherboard over the rubber pad and metal baseboard so that the screws match up with the motherboard’s screw holes.

Motherboard

Screws

Place eight screws in the areas circled on the motherboard. The four screws used with the moth- erboard spacers are longer than the others. (See page 20 for samples.) Be careful not to over- tighten the screws. Doing so may damage your motherboard.

18	AP8000 Hardware Reference Guide

Contents

Page AP8000 Hardware Reference Guide ASUSTeK COMPUTER INC. (Asia-Pacific) Marketing Technical Support ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Europe) I. Introduction II. Components III. Basic Operation IV. Hardware Setup Page Federal Communications Commission Statement Canadian Department of Communications Statement •1-1.How this Manual is Organized Symbols •1-2.Component Checklist Standard components Optional components •1-3.Features •1-4.Safeguards Operation Safety Tools Required •1-5.Electrical Safety Static-SensitiveDevices (This page was intentionally left blank.) •2-1.Server Front Side •2-2.Server Back Side •2-3.Server Left Side •3-1.Starting the Server • 3-2.LED Indicators • 3-3.BIOS Setup • 4-1.Opening the Chassis Chassis Panels Opening the Left Panel Fan • 4-2.Motherboard Spacers Install the Baseboard Screws Device Cables Cable Connections • 4-3.Central Processing Unit (CPU) Install Retention Mechanisms Mechanism Brace Bars Install Cartridge Lifters Mechanism Cap Frame • 4-4.Chassis Intrusion Switch Chassis Intrusion Connector • 4-5.Expansion Cards • 4-8.Fixed Storage Devices Fixed Storage Device Tray Fixed Device Bay Cover Clips • 4-7.Floppy Disk Drive and CD-ROM Floppy Disk Drive CD-ROMDrive • 4-8. Hot-SwapTrays Removing Hot Swap Trays Hot-SwapTray Usage Hot-SwapTray Front Connections Hot-SwapTray Interface • 4-9. Hot-SwapTray Connector Board Hot-SwapTray Rear Connections • 4-10.SCSI Backplane • 4-11.SCSI ID Setting Using the SCSI Backplane Boards Separately Using Cascaded SCSI Backplane Boards • 4-12.SCSI Backplane Board Placement Installing & Removing SCSI Backplane Boards SCSI Hard Disk Connections • 4-13.Circulation System Fan Module • 4-14.Power Supply Redundant Power Supply Mounting Removing Removing the Entire Power Supply Unit Power Module Rating Power Module Failure Power Supply Information Power Supply Requirement Page i.SCSI Cable Limits ii. Glossary PCI Bus (Peripheral Component Interconnect Local Bus) Peripherals POST (Power On Self Test) PS/2 Port RAID (Redundant Array of Inexpensive Disks)