IV. Hardware Setup
• 4-10. SCSI Backplane
The SCSI backplane of this server is comprised of two SCSI backplane boards with a 68-pin SCSI connector, power input, and SCSI ID dip switches on each SCSI backplane board. This configuration allows Ultra2 or Wide-SCSI hard disk drives to be docked into the server using a common connector. The female end is located on the SCSI backplane board, while the male end is located on the hot-swap tray.
68-pin Ultra2 or Wide-SCSI Connector
SCSI ID Dip Switches
SCSI Backplane Board
Power #1
SCSI Backplane Board
Power #2
SCSI Terminator
68-pin Ultra2 or Wide-SCSI Connector
SCSI Backplane Board Back SideIMPORTANT
The DA-BP4 SCSI backplane board has automatic termination. If using Ultra-wide devices, make sure the termination on each device is disabled.