Celestron AP8000 Device Cables, Cable Connections

IV. Hardware Setup

CD-ROM Drive Cable

Floppy Disk Drive Cable

68-pin SCSI Cable

Power SW

HDD LED

Power LED

Chassis Intrusion

Connector Cable

Device Cables

Several cables are used for connecting devices in this chassis. The following picture points out the name of each cable and its suggested location. Plastic keepers protect the cables from contacting with the fans and other devices. Make sure that all cables are properly secured.

CD-ROM Drive Cable

Floppy Disk

Drive Cable

68-pin SCSI Cable

Hardware Setup	Motherboard
IV.

Cable Connections

The cables connect to the motherboard as shown. The motherboard includes onboard SCSI with 68-pin and 50-pin SCSI connectors. RAID connections require an optional RAID card.

AP8000 Hardware Reference Guide

Contents

Page AP8000 Hardware Reference Guide ASUSTeK COMPUTER INC. (Asia-Pacific) Marketing Technical Support ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Europe) I. Introduction II. Components III. Basic Operation IV. Hardware Setup Page Federal Communications Commission Statement Canadian Department of Communications Statement •1-1.How this Manual is Organized Symbols •1-2.Component Checklist Standard components Optional components •1-3.Features •1-4.Safeguards Operation Safety Tools Required •1-5.Electrical Safety Static-SensitiveDevices (This page was intentionally left blank.) •2-1.Server Front Side •2-2.Server Back Side •2-3.Server Left Side •3-1.Starting the Server • 3-2.LED Indicators • 3-3.BIOS Setup • 4-1.Opening the Chassis Chassis Panels Opening the Left Panel Fan • 4-2.Motherboard Spacers Install the Baseboard Screws Device Cables Cable Connections • 4-3.Central Processing Unit (CPU) Install Retention Mechanisms Mechanism Brace Bars Install Cartridge Lifters Mechanism Cap Frame • 4-4.Chassis Intrusion Switch Chassis Intrusion Connector • 4-5.Expansion Cards • 4-8.Fixed Storage Devices Fixed Storage Device Tray Fixed Device Bay Cover Clips • 4-7.Floppy Disk Drive and CD-ROM Floppy Disk Drive CD-ROMDrive • 4-8. Hot-SwapTrays Removing Hot Swap Trays Hot-SwapTray Usage Hot-SwapTray Front Connections Hot-SwapTray Interface • 4-9. Hot-SwapTray Connector Board Hot-SwapTray Rear Connections • 4-10.SCSI Backplane • 4-11.SCSI ID Setting Using the SCSI Backplane Boards Separately Using Cascaded SCSI Backplane Boards • 4-12.SCSI Backplane Board Placement Installing & Removing SCSI Backplane Boards SCSI Hard Disk Connections • 4-13.Circulation System Fan Module • 4-14.Power Supply Redundant Power Supply Mounting Removing Removing the Entire Power Supply Unit Power Module Rating Power Module Failure Power Supply Information Power Supply Requirement Page i.SCSI Cable Limits ii. Glossary PCI Bus (Peripheral Component Interconnect Local Bus) Peripherals POST (Power On Self Test) PS/2 Port RAID (Redundant Array of Inexpensive Disks)