Setup Hardware .IV
Connector
IV. Hardware Setup
• 4-9. Hot-Swap Tray Connector Board
The connector board is mounted on the
|
|
|
|
|
| ID0 |
|
|
|
|
|
| ID1 |
|
| LED0 |
|
|
| ID2 |
|
| LED1 |
| RD | ID3 | |
|
| LED2 |
| BL | ||
KEY | Red | ALED_IN | BK | YE | ||
| Orange | Red |
|
| ||
| Black | Black | OR | Connector | ||
| Green | Green | Black | WH | ||
|
|
|
| BR | GR |
Wide SCSI Connector
Docking Connector
Hard Disk Drive
Power Connector
Hot-Swap Tray Connector Board Parts
Hot-Swap Tray Rear Connections
KEY: These 2 pins connect to the keylock on the tray’s front panel to turn ON and OFF the drive’s power.
LED0: These 3 pins connect to the hard drive access LED on the front of the tray to show when the hard disk drive accesses data.
LED1: (Reserved)
LED2: These 3 pins connect to the power LED on the front of the tray to show when the connector board receives power.
ALED_In: These 2 pins connect to the hard drive access LED on the back of the hard drive to show when the hard drive accesses data.
SCSI_ID: These 8 pins connect to the hard drive’s SCSI address pins to set the SCSI ID number of the hard disk drive.
Hot-Swap Tray Docking Connector: Connects to the SCSI
backplane board.
Hard Disk Drive Power Connector: Connects to the hard drive.
28 | AP8000 Hardware Reference Guide |