PYROMASTER@ UVHB26 Vent-Free Heaters
D 10. lOG INSTAllATION (refer to fig. 9)
1.Set the back log on the studs attached to the burner pan.
2.Install the front log
and front lip of the unit. This should be a snug fit.
3.Set the "Y"log in the notches in the front and rear logs.
4.Set the right cross log in the right notch of the front log and the other end on the dimple of the "Y" log.
5.Set the left cross log on the dimple of the "Y" cross log and the opposite end in the groove in the back of the front log.
~ | NOTCHES FOR "Y" |
L L | LOG LOCATION |
~ | oil(REAR LOG |
| rt | DIMPLES TO | |
| 0 |
| |
NOTCHES |
| U | LOCATE CROSS |
| LOGS | ||
TO LOCATE~ |
| ||
|
| ||
LOGS | ~ ~~ |
| |
| F | q/~ | FRONT LOG |
| RIGHT LOG |
LEFT LOG ~REARLOG | FRONT LOG |
"Y" LOG |
|
| FP734 |
Fig. 9. Log locations. |
|
:)
~"
<~:#
D 9. ROCK PLACEMENT
1. lava Rock
The lava rock provided with this heater must be placed on the wire screen in the center of the burner tube. Place just enough lava rock to cover the screen. Do not pile the rock.
.. 2. Volcanic rock
h Spread the volcanic rock (gravel size) on the burner pan of the fireplace. This
will give the fireplace a realistic look.
Under no circumstances should this lava rock be placed on any part of the burner tube.
.,~)
10
