![](/images/new-backgrounds/1013855/1385517x1.webp)
PYROMASTER@ UVHB26 Vent-Free Heaters
A WHEN INSTALLED, THE HEATER MUST BEELECTRICALLY CON- NECTED AND GROUNDED IN AC- CORDANCE WITH LOCAL CODES
OR, IN THE ABSENCE OF LOCAL CODES:
U.S. INSTALLATIONS: FOLLOW LOCAL CODES AND THE NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70.
D OPTIONAL
6.REMOTE WALL SWITCH (RN AND RP MODELS ONLY)
1.Thread wire through the square hole located on either side of unit. Do not cut wire or insula-
tion on metal edges. Ensure that wire is pro- tected. Run the other end to a conveniently located wall receptacle box.
2.Attach wire to switch and install switch into receptacle box. Attach cover plate to switch.
3.Connect wiring to gas valve. Loosen the
"'J
',>,.J'/ screws, remove jumper as shown in Fig 7. Install one lead from the wall switch to TH.
Install the other lead to TH/TP.
CAUTION: DO NOT WIRE MILLI- A VOLT REMOTE WALL SWITCH FOR
GAS HEATER TO A 120V POWER
SUPPLY. For lighting instructions, see page 11.
4.To turn the gas valve on, put the wall switch to the 'ON'position.
D 7. BOTTOM LOUVRE (GRILLE) REMOVAL
To remove the bottom louvre (grille), lift louvre up and then out. See Figure 8.
VALVE
ON/OFF
SWITCH
FP382A
Fig. 7. Remote switch wiring.
=
"""'~
""',.~
""" ..
""" '0'
""""
"""'~
""'.~
""""
"'01._..
RILLE""'1_'
"""'"
~ .."'.,,~
G"""'"
""".",
(LOUVRE) T.,.:; D
FP733
Fig. 8. Louvre installation and removal.
9