Assembly Step 4 - Install the Tank Retainer
USE HARDWARE ”C”
Tools Needed:
Phillips head screwdriver
A M4 Wing | B M4x10mm | C M6 Wing |
Nut (1) | Bolt (1) | Nut (6) |
1. Insert the legs of the wire tank retainer |
LOCATE THESE PARTS:
B
A
Wire
into the mounting brackets inside the grill |
legs. The wire tank retainer must be |
mounted on the wheel side of the grill. |
2. Align the center hole of the |
insert the M4 bolt through both wires, and |
thread on the M4 wing nut as |
shown above right. |
3. Insert the ends of the wire |
into the mounting |
holes located |
near the |
middle of the grill legs
and threadC a M6 wing
nut onto each end.
4. Thread M6 wing nuts onto the ends of the wire tank retainer.
Wire Tank
Retainer
C
13
