ASSEMBLY STEP 1
For Sliding and Swinging Gates ONLYAssemble the Rail and
Attach the Chain Pulley Bracket
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
1.Place the 3 rail sections on a flat surface for assembly. The end sections are identical. Make sure the
"arrow label" on the center section is pointing in the direction shown in the illustration.
2.Connect the center section and the 1/4" lock nuts to the end sections from the same side, as shown.
NOTE: If rail is not assembled exactly as shown, trolley will not travel smoothly along length of rail or it will hit against nuts.
3.Insert the carriage bolts from the opposite side of the end sections. Tighten the nuts. When assembled, rail has a
4.Position the chain pulley bracket on the front end of the rail as shown. Fasten securely with the hardware provided.
NOTE: When tightening the bolts be sure to keep bracket parallel to the rail. Otherwise, the rail may bow when the opener is operated.
| DOOR |
GE | |
GARA |
|
TO |
|
Brace
HARDWARE SHOWN ACTUAL SIZE
Carriage Bolts
Lock Nut
Hex Bolt | Nut | Lock Washer |
5/16" |
11 mm Socket Wrench
Chain pulley bracket attaches to this end of Rail
1/4'' Lock Nut | Rail | |
(End Section) | ||
|
Brace
AWAY FROM
OPENER
Carriage Bolt
Rail
(Center Section)
Rail
(End Section)
Square Carriage
Bolt Holes
|
| Hex Bolts | ||
|
| |||
|
|
|
| ned |
|
|
|
| g |
|
|
| Be | Ali |
|
| Must |
| |
| Rail |
|
| |
|
|
|
| |
| & |
|
|
|
Rail | Bracket |
|
|
|
|
|
|
|
El sostÈn de la polea
Chain Pulley
del cable se fija a este extremo del riel. Bracket
Rail connects to opener at this end.
| Riel | Lock Washer |
Tuerca de 1/4" | 5/16" | |
Nut |
| |
| (SecciÛn |
|
| 5/16" |
|
13 mm Socket Wrench
10