![](/images/backgrounds/52457/52457-8026x1.png)
Please read and comply with the warnings and reinforcement instructions on the previous page. They apply to
•Center the door bracket on the top of the door, in line with the header bracket as shown. Mark either the left and right, or the top and bottom holes.
•Drill 8 mm pilot holes and fasten the bracket with hardware provided.
If the door has no exposed framing, drill 5 mm pilot holes and fasten the bracket with
NOTE: The door bracket may be installed on the top edge of the door if required for your installation. (Refer to the dotted line optional placement drawing.) Drill 5 mm pilot holes and substitute
Header Wall
Finished Ceiling
38 mm Support
HARDWARE SHOWN ACTUAL SIZE
Nut | Lock Washer 5/16" |
Carriage Bolt
Header
Bracket
Door
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline of
Garage Door
Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, aluminum, steel, door with glass panel, etc.) (not provided).
Nut
Door
Bracket
For a door with no exposed framing, or for the optional installation, use
Lock
Washer 5/16"
Top of Door
(Inside Garage)
Top Edge
of Door
Optional
Placement
Carriage Bolt
13 mm Socket Wrench
26