ASSEMBLY STEP 4
For Sliding and Swinging Gates OnlyInstall the Chain
and Attach the Sprocket Cover
INSTALLING THE CHAIN | Leave Chain | |
1. Dispense a few inches of | & Cable | |
chain from carton and | Inside Carton to | |
Prevent Kinking | ||
fasten to trolley with a |
| |
master link from the |
| |
hardware bag. (Figure 1). | Keep Chain | |
• Push pins of master link | ||
Taut When Dispensing |
bar through chain link
and hole in front end of trolley.
•Push master link cap over pins and past pin notches.
•Slide
2.To prevent the trolley from jamming against the opener during operation, position trolley 5 to 15 cm from the stop hole as shown. Then dispense the chain around the opener sprocket (Figure 1). Make sure the sprocket teeth engage the chain.
•Proceed around to the pulley bracket and forward to the threaded trolley shaft.
3.Use the second master link to connect the chain to the flat end of the shaft (Figure 1). Check to make sure the chain is not twisted.
ATTACHING THE SPROCKET COVER 1215E ONLYInsert the back tab in the slot on the back of the mounting plate. Squeeze the cover slightly and insert the front tab.
WARNING
To avoid possible SERIOUS INJURY to fingers from moving opener:
•ALWAYS keep hand clear of sprocket while operating opener.
•Securely attach sprocket cover BEFORE operating.
Figure 1
| Master Link |
| |
| Master |
Master Link | Link Cap |
| |
Flat End of | |
| |
Master | Threaded Shaft |
| |
Link Cap |
|
Sprocket
Cover
Back Tab
Install Chain
in this Direction
Sprocket
Back
Tab Slot
Chain Link
| Flat End |
|
| of Trolley |
|
| Chain Link | Master |
|
| |
Rail |
| Link |
| Pin | |
Chain | Trolley | Pin Notch |
| ||
|
| |
| Master |
|
| Link Pin |
|
| Pin Notch |
|
| Trolley Stop |
|
| (Hex Bolt) |
|
Mounting
Plate
Motor Unit
14