INSTALLATION STEP 7
Electrical Requirements
To avoid installation difficulties, do not run the operator at this time.
To reduce the risk of electric shock, your operator has a grounding type plug with a third grounding pin. This plug will only fit into a grounding type outlet. If the plug doesn’t fit into the outlet you have, contact a qualified electrician to install the proper outlet.
RIGHTWRONG
If permanent wiring is required by your local code, refer to the following procedure.
To make a permanent connection through the 7/8" hole in the back of the operator (according to local code):
•Remove the operator from the torsion bar, remove cover screws and set the cover aside.
•Remove the attached green ground terminal.
•Cut black and white wires and strip away 1/2" (1.3 cm) of insulation, 3" (7.6 cm) before spade terminals.
•Remove the power cord from unit.
•Install a 90o conduit or flex cable adapter to the 7/8" hole. Reinstall operator to torsion bar.
•Run wires through conduit, cut to proper length and strip insulation.
•Attach with wire nuts provided.
•Properly secure wire under plastic ties so that wire does not come in contact with moving parts.
•Reinstall the cover.
To avoid installation difficulties, do not run the operator at this time.
To prevent possible SERIOUS INJURY or DEATH from electrocution or fire:
•Be sure power is not connected to the operator, and disconnect power to circuit BEFORE removing cover to establish permanent wiring connection.
•Door installation and wiring MUST be in compliance with ALL local electrical and building codes.
•NEVER use an extension cord,
PERMANENT WIRING CONNECTION
Flexible conduit
Green
Ground
Screw
Ground Tab Ground Wire
Black Wire
From Power Cord
White Wire
From Power Cord
PERMANENT WIRING CONNECTION
Black Wire
Green Wire
90˚ Connector
12
White Wire